ProCurve 2610-PWR Technical Information download pdf (Page 347)

ProCurve Stack Management

Configuring Stack Management

Syntax: no stack name < stack name>

stack join < mac-address >

If you don’t know the MAC address of the destination Commander, you can

use

show stack all to identify it.

For example, suppose you have a switch operating as the Commander for a

temporary stack named “Test”. When it is time to eliminate the temporary

“Test” stack and convert the switch into a member of an existing stack named

“Big_Waters”, you would execute the following commands in the switch’s CLI:

Figure 8-33. Example of Command Sequence for Converting a Commander to a Member

Eliminates the “Test” stack and converts

the Commander to a Candidate.

Helps you to identify the MAC address of the

Commander for the “Big_Waters” stack.

Adds the former “Test” Commander to the

“Big_Waters” stack.

Using the CLI To Remove a Member from a Stack

You can remove a Member from a stack using the CLI of either the Commander

or the Member.

Note When you remove a Member from a stack, the Member’s Auto Join parameter

is set to No.

Using the Commander CLI To Remove a Stack Member. This option

requires the switch number (SN) and the MAC address of the switch to

remove. (Because the Commander propagates its Manager password to all

stack members, knowing the Manager password is necessary only for gaining

access to the Commander.)

Syntax: [no] stack member <switch-num> mac-address <mac-addr>

8-41

1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 347