ProCurve 2610-PWR Technical Information download pdf (Page 62)

Static Virtual LANs (VLANs)

Port-Based Virtual LANs (Static VLANs)

Figure 2-28. Example of Management VLAN Control in a LAN

Table 2-3. VLAN Membership in Figure 2-28

Switch A1 A3 A6 A7 B2 B4 B5 B9 C2 C3 C6 C8

Management VLAN (VID = 7) Y N N Y Y Y N N Y N N N

Marketing VLAN (VID = 12) N N N N N N N N N Y Y Y

Shipping Dept. VLAN (VID = 20) N Y Y N N N N N N N N N

DEFAULT-VLAN (VID = 1) Y Y Y Y Y Y Y Y Y Y Y Y

Preparation

1. Determine a VID and VLAN name suitable for your Management VLAN.

2. Determine the IP addressing for the Management VLAN (DHCP/Bootp or

Manual.

3. Plan your Management VLAN topology to use ProCurve switches that

support this feature. (See the list on page 2-34.) The ports belonging to the

Management VLAN should be only the following:

• Ports to which you will connect authorized management stations

(such as Port A7 in figure 2-28.)

• Ports on one switch that you will use to extend the Management VLAN

to ports on other ProCurve switches (such as ports A1 and B2 or B4

and C2 in figure 2-28 on page 2-36.).

Hubs dedicated to connecting management stations to the Management VLAN

can also be included in the above topology. Note that any device connected

to a hub in the Management VLAN will also have Management VLAN access.

4. Configure the Management VLAN on the selected switch ports.

5. Test the management VLAN from all of the management stations autho-

rized to use the Management VLAN, including any SNMP-based network

management stations. Ensure that you include testing any Management

VLAN links between switches.

Note If you configure a Management VLAN on a switch by using a Telnet connection

through a port that is not in the Management VLAN, then you will lose

management contact with the switch if you log off your Telnet connection or

execute write memory and reboot the switch.

2-36

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 62