ProCurve 2610-PWR Technical Information download pdf (Page 63)

Static Virtual LANs (VLANs)

Port-Based Virtual LANs (Static VLANs)

Configuration

Syntax: [ no ] management-vlan < vlan-id | vlan-name >

Default: Disabled

To confirm the Management VLAN configuration, use the

show running-config command.

For example, suppose you have already configured a VLAN named My_VLAN

with a VID of 100. Now you want to configure the switch to do the following:

■ Use My_VLAN as a Management VLAN (tagged, in this case) to connect

port A1 on switch “A” to a management station. (The management station

includes a network interface card with 802.1Q tagged VLAN capability.)

■ Use port A2 to extend the Management VLAN to port B1 (which is already

configured as a tagged member of My_VLAN) on an adjacent switch.

ProCurve

Switch

“

B”

ProCurve

Switch

“A”

Figure 2-29. Illustration of Configuration Example

ProCurve(config)# management-vlan 100

ProCurve(config)# vlan 100 tagged a1

ProCurve(config)# vlan 100 tagged a2

Deleting the Management VLAN. You can disable the Secure Manage-

ment feature without deleting the VLAN itself. For example, either of the

following commands disables the Secure Management feature in the above

example:

ProCurve(config)# no management-vlan 100

ProCurve(config)# no management-vlan my_vlan

Operating Notes for Management VLANs

■ Only one Management-VLAN can be active in the switch. If one Manage-

ment-VLAN VID is saved in the startup-config file and you configure a

different VID in the running-config file, the switch uses the running-config

version until you either use the write-memory command or reboot the

switch.

2-37

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 63