ProCurve 2610-PWR Technical Information download pdf (Page 349)

ProCurve Stack Management

Configuring Stack Management

You would then execute this command in the “North Sea” switch’s CLI to

remove the switch from the stack:

North Sea(config)# no stack join 0030c1-7fec40

Using the CLI To Access Member Switches for Configuration

Changes and Traffic Monitoring

After a Candidate becomes a Member, you can use the telnet command from

the Commander to access the Member’s CLI or console interface for the same

configuration and monitoring that you would do through a Telnet or direct-

connect access from a terminal.

Syntax: telnet <switch-number>

where: unsigned integer is the switch number (SN) assigned by the

Commander to each member (range: 1 - 15).

To find the switch number for the Member you want to access, execute the

show stack view command in the Commander’s CLI. For example, suppose that

you wanted to configure a port trunk on the switch named “North Sea” in the

stack named “Big_Waters”. Do do so you would go to the CLI for the

“Big_Waters” Commander and execute show stack view to find the switch

number for the “North Sea” switch:

The switch number

(SN) for the “North

Sea” switch is “3”.

Figure 8-36. Example of a Stack Showing Switch Number (SN) Assignments

To access the “North Sea” console, you would then execute the following

telnet

command:

ProCurve(config)# telnet 3

You would then see the CLI prompt for the “North Sea” switch, allowing you

to configure or monitor the switch as if you were directly connected to the

console.

8-43

1 2 ... 344 345 346 347 348 349 350 351 352 353 354 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 349