ProCurve 2610-PWR Technical Information download pdf (Page 122)

Spanning-Tree Operation

Configuring Rapid Reconfiguration Spanning Tree (RSTP)

CLI: Configuring RSTP

Spanning Tree Commands in This Section STP RSTP Page for RSTP Use

show spanning-tree config Y Y Below on this page

spanning-tree Y Y page 5-15

protocol-version <rstp | stp> Y Y page 5-16

force-version N Y page 5-16

<rstp-operation | stp-compatible>

forward-delay <4 - 30> Y Y page 5-16

hello-time <1 - 10> Y Y page 5-16

maximum-age <6 - 40> Y Y page 5-16

priority <0 - 15 | 0 - 65535> Y Y page 5-16

<[ethernet] port-list> Y Y page 5-18

path-cost <1 - 200 000 000> Y Y page 5-18

priority <0 - 15 | 0 - 65535> Y Y page 5-18

edge-port N Y page 5-18

point-to-point-mac N Y page 5-18

mcheck N Y page 5-18

mode <norm | fast> Y N Refer to “802.1D Spanning-

Tree Protocol (STP)” on page

5-23.

show spanning-tree This command lists additional RSTP/STP/

MSTP monitoring data that is not covered in

this section. Refer to the section titled

“Spanning Tree Protocol Information” in the

“Monitoring and Analyzing Switch

Operation” appendix of the Management and

Configuration Guide for your switch.

Viewing the Current Spanning Tree Configuration. Use this command

to display the current spanning tree configuration.

Syntax: show spanning-tree configuration

Lists the switch’s full spanning tree configuration,

including whole-switch and per-port settings, regardless

of whether spanning tree is disabled.

(Default: n/a; Abbreviated Command: sho span config)

In the default configuration, the output from this command appears similar to

the following:

5-14

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 122