ProCurve 2610-PWR Technical Information download pdf (Page 346)

ProCurve Stack Management

Configuring Stack Management

Syntax: stack member < switch-number >

mac-address < mac-addr >

[ password < password-str >]

In the destination Commander, use show stack all to find the MAC address of

the Member you want to pull into the destination stack. For example, suppose

you created a new Commander with a stack name of “Cold_Waters” and you

wanted to move a switch named “Bering Sea” into the new stack:

Move this switch into the “Cold Waters” stack.

Figure 8-32. Example of Stack Listing with Two Stacks in the Subnet

You would then execute the following command to pull the desired switch

into the new stack:

ProCurve(config)# stack member 1 mac-address 0060b0-

df1a00

Where 1 is an unused switch number (SN).

Since a password is not set on the Candidate, a password is not needed in this

example.

You could then use show stack all again to verify that the move took place.

Using a Member CLI To “Push” the Member into Another Stack. You

can use the Member’s CLI to “push” a stack Member into a destination stack

if you know the MAC address of the destination Commander.

Syntax: stack join <mac-addr>

where: < mac-addr > is the MAC address of the Commander for the

destination stack.

Converting a Commander to a Member of Another Stack. Removing

the Commander from a stack eliminates the stack and returns its Members to

the Candidate pool with

Auto Join disabled.

8-40

1 2 ... 341 342 343 344 345 346 347 348 349 350 351 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 346