ProCurve 2610-PWR Technical Information download pdf (Page 245)

Quality of Service (QoS): Managing Bandwidth More Effectively

Using QoS Classifiers To Configure QoS for Outbound Traffic

Note A codepoint must have an 802.1p priority assignment (0 - 7) before you can

configure that codepoint as a criteria for prioritizing packets by source-port.

If a codepoint shows No-override in the Priority column of the DSCP Policy

Table (show qos dscp-map), then you must assign a 0 - 7 priority before

proceeding.

4. Configure the switch to assign the DSCP policy to packets from the

specified source-port.

Syntax: qos dscp-map < codepoint > priority < 0 - 7 >

This command is optional if a priority has already

been assigned to the < codepoint >. The command creates

a DSCP policy by assigning an 802.1p priority to a

specific DSCP. When the switch applies this priority to

a packet, the priority determines the packet’s queue in

the outbound port to which it is sent. If the packet leaves

the switch on a tagged port, it carries the 802.1p

priority with it to the next downstream device.

(Default: For most codepoints,

No-override. See figure 6-

11 on page 6-59 on page 6-59.)

Syntax: interface < port-list > qos dscp < codepoint >

Assigns a DSCP policy to packets from the specified

source-port(s), and overwrites the DSCP in these

packets with the assigned <

codepoint > value. This policy

includes an 802.1p priority and determines the

packet’s queue in the outbound port to which it is sent.

If the packet leaves the switch on a tagged port, it

carries the 802.1p priority with it to the next

downstream device. (Default:

No-override)

no interface [e] < port-list > qos

Removes QoS classifier for the specified source-port(s).

show qos source-port

Displays a listing of all source-port QoS classifiers

currently in the running-config file.

6-55

1 2 ... 240 241 242 243 244 245 246 247 248 249 250 ... 363 364

No comments

ProCurve 2610-PWR Technical Information Page 245