10-9
Access Control Lists (ACLs)
Overview of Options for Applying ACLs on the Switch
Table 10-3. Command Summary for Enabling, Disabling, and Displaying ACLs
Enter or Remove a
Remark
ProCurve(config)# ip access-list extended < name-str | 100-199 >
ProCurve(config-ext-nacl)# [ remark < remark-str > | no remark ]
For numbered, extended ACLs only, the following remark commands can be
substituted for the above:
ProCurve(config)# access-list < 100 - 199 > remark < remark-str >
ProCurve(config)# [no] access-list < 100 - 199 > remark
10-92
10-94
Delete an Extended
ACL
ProCurve(config)# no ip access-list extended < name-str | 100-199 >
For numbered, extended ACLs only, the following command can also be used:
ProCurve(config)# no access-list < 100 - 199 >
10-85
Action Command(s) Page
Enable or Disable an
RACL
ProCurve(config)# [no] vlan < vid > ip access-group < identifier > < in | out > 10-81
Enable or Disable a
VACL
ProCurve(config)# [no] vlan < vid > ip access-group < identifier > < vlan >
Enable or Disable a
Static Port ACL
ProCurve(config)# [no] interface < port-list | Trkx > access-group < identifier > in
ProCurve(eth-< port-list >| Trkx >)# [no] ip access-group < identifier > in
Displaying ACL Data ProCurve(config)# show access-list
ProCurve(config)# show access-list < acl-identifier >
ProCurve(config)# show access-list config
ProCurve(config)# show access-list vlan < vid >
ProCurve(config)# show access-list radius
10-96
Comments to this Manuals