IP Routing Features
Configuring RIP
■ Queries – The number of RIP queries that have been received by the
routing switch.
■ RIP Interface Information – RIP information on the VLAN interfaces
on which RIP is enabled.
• IP Address – IP address of the VLAN interface running rip.
• Status – Status of RIP on the VLAN interface.
• Send mode – The format of the RIP updates: RIP 1, RIP 2, or RIP 2
version 1 compatible.
• Recv mode – The switch can process RIP 1, RIP 2, or RIP 2 version
1 compatible update messages.
• Metric – The path “cost”, a measurement used to determine the 'best'
RIP route path; 1 is the best, 15 is the worse, 16 is unreachable.
• Auth – RIP messages can be required to include an authentication
key if enabled on the interface.
■ RIP Peer Information – RIP Peers are neighboring routers from which
the routing switch has received RIP updates.
• IP Address – IP address of the RIP neighbor.
• Bad routes – The number of route entries which were not processed
for any reason.
• Last update timeticks – How many seconds have passed since we
received an update from this neighbor.
Syntax: show ip rip
Displaying RIP Interface Information
To display RIP interface information, enter the show ip rip interface command
at any context level. The resulting display will appear similar to the following:
Figure 5-4.Example of Show IP RIP Interface Output
5-35
Comments to this Manuals