ProCurve 3400cl Technical Information download pdf (Page 243)

Configuring Port-Based Access Control (802.1x)

Messages Related to 802.1x Operation

Table 9-4. 802.1x Operating Messages

Message Meaning

Port

< port-list > is not an authenticator. The ports in the port list have not been enabled as 802.1x

authenticators. Use this command to enable the ports as

authenticators:

HPswitch(config)# aaa port-access

authenticator e 10

Port

< port-list > is not a supplicant. Occurs when there is an attempt to change the supplicant

configuration on a port that is not currently enabled as a

supplicant. Enable the port as a supplicant and then make

the desired supplicant configuration changes. Refer to

“Enabling a Switch Port To Operate as a Supplicant” on

page 9-34.

No server(s) responding. This message can appear if you configured the switch for

EAP-RADIUS or CHAP-RADIUS authentication, but the

switch does not receive a response from a RADIUS server.

Ensure that the switch is configured to access at least one

RADIUS server. (Use show radius.) If you also see the

message Can’t reach RADIUS server <

x.x.x.x >, try the suggestions listed for that message

(page 5-1).

LACP has been disabled on 802.1x port(s).

To maintain security, LACP is not allowed on ports

configured for 802.1x authenticator operation. If you

configure port security on a port on which LACP (active or

passive) is configured, the switch removes the LACP

configuration, displays a notice that LACP is disabled on the

port(s), and enables 802.1x on that port.

Error configuring port

< port-number >:

Also, the switch will not allow you to configure LACP on a

LACP and 802.1x cannot be run together.

port on which port access (802.1x) is enabled.

9-47

1 2 ... 238 239 240 241 242 243 244 245 246 247 248 ... 313 314

No comments

ProCurve 3400cl Technical Information Page 243